Seadog
Member
Had and issue just crop up. No.2 motor after a min or two stops. I replaced motor, replaced esc resoldered wires etc. yet after around 1 min. of running the motor quits. I was about 5 ft. in the air and it flipped and hit the street breaking one arm. Replaced arm and I flew it in the yard over snow so if issue would not break anything. I had timer on TX going. Was about 4 mins into flight and did the same. So I replaced motor with same model and esc also. This time I didn't want to take a chance so just armed and kept it on the ground not going up. Same thing. No.2 quit but this time after about 1 min. of running. I reflashed the firmware just to be sure. Kinda of at a loss as to what could cause it. Naza pointed in right direction, wires on right connections right way, red wire disconnected from all. At a loss right now. Seemed to have been flying nice in the past.