Hi, after a perfect experience with my unit (octocopter s802) I updated the firmware and I can not fly.
This is what is happening, I connect the unit, everything seems normal, in attitude mode, I get the yellow LED constant signals, I do the startup TX gesture, it starts the motors for a few seconds AND THEN I GET SEVERAL BLUE SIGNALS ON THE LED. I do the gesture again, I can briefly lift the unit, and then the LED turns RED, and it forces the unit to land.
According the the manual, I have to reboot the Main Controller (MC), I do so, by unplugging the battery; I have repeated this gesture several times, and I have the same problem. I assumed rebooting the MC was to unplug the batteries, and restart the unit.
Nothing is working. Any suggestions?
This is what is happening, I connect the unit, everything seems normal, in attitude mode, I get the yellow LED constant signals, I do the startup TX gesture, it starts the motors for a few seconds AND THEN I GET SEVERAL BLUE SIGNALS ON THE LED. I do the gesture again, I can briefly lift the unit, and then the LED turns RED, and it forces the unit to land.
According the the manual, I have to reboot the Main Controller (MC), I do so, by unplugging the battery; I have repeated this gesture several times, and I have the same problem. I assumed rebooting the MC was to unplug the batteries, and restart the unit.
Nothing is working. Any suggestions?