Newbie with an mQX

simple1974

New Member
Hi there,
I have been flying my mQX for a couple of weeks now with my DX8 and am loving it. However yesterday i went to bank left and the rear left blade stopped and there was a whining noise. I picked up the unit and checked that all the motoers and gear cogs were fine and in place and correctly aligned and could see no apparent physical issue. Holding the unit i then powered up and all 4 blades spun but when i banked left the rear left stopped again and made a whining noise. I repeated but this time the rear left blade wouldnt turn at all even with a straight power up - just the whining noise. All other blades are fine? I turned all off and then re-bound the DX8 to the mQX but still the same.

Any ideas anyone - is it a seized motor or issue with the mother board?

any thoughts gratefully appreciated.

Borneo Aerials
 

ponchota

Member
Def. sounds like a motor or nylon gear issue. Everything spins freely when you spin the props by hand, no slight slip or catching? Examine the teeth on the nylon gears, all it takes is a warn tooth or 2 to do that, they are so small you may not even see the wear. It's a good idea to have spare gears and blades on hand. Spares for this are cheap but they will nickel and dime you to death. I make my own CF arms, and get my knock off spares from Banggood.com. Take awhile to come but wayyy cheaper. One smackaroo for 2 gears, I bought 2 motors for $7 etc. etc Look for WLtoys V929/V949 parts .

Good Luck!
Mike
 

ponchota

Member
Forgot to mention, check the shaft and motor housing as well. The shaft could have a split or the housing could be cracked causing the main gear to pull away from the pinion just enough to make the gears slip.:encouragement:
 

Top