simple1974
New Member
Hi there,
I have been flying my mQX for a couple of weeks now with my DX8 and am loving it. However yesterday i went to bank left and the rear left blade stopped and there was a whining noise. I picked up the unit and checked that all the motoers and gear cogs were fine and in place and correctly aligned and could see no apparent physical issue. Holding the unit i then powered up and all 4 blades spun but when i banked left the rear left stopped again and made a whining noise. I repeated but this time the rear left blade wouldnt turn at all even with a straight power up - just the whining noise. All other blades are fine? I turned all off and then re-bound the DX8 to the mQX but still the same.
Any ideas anyone - is it a seized motor or issue with the mother board?
any thoughts gratefully appreciated.
Borneo Aerials
I have been flying my mQX for a couple of weeks now with my DX8 and am loving it. However yesterday i went to bank left and the rear left blade stopped and there was a whining noise. I picked up the unit and checked that all the motoers and gear cogs were fine and in place and correctly aligned and could see no apparent physical issue. Holding the unit i then powered up and all 4 blades spun but when i banked left the rear left stopped again and made a whining noise. I repeated but this time the rear left blade wouldnt turn at all even with a straight power up - just the whining noise. All other blades are fine? I turned all off and then re-bound the DX8 to the mQX but still the same.
Any ideas anyone - is it a seized motor or issue with the mother board?
any thoughts gratefully appreciated.
Borneo Aerials