jamerslong
New Member
Hey I am planning my first quad build. I would like to offer my shopping list for a little feedback anything that is wrong in your opinion or something that's missing. The entire purchase will be from banggood.com.
Frame - Tarot 280mm TL280H (glass/carbon mix)
Motors - DYS be1806 2300kv
ESC - emax BLHeli 20a (can I use 12a version)
Flight Controller - APM 3.1 mini
-GPS
-Bluetooth
-MinimOSD MAVlink (do I need a usb dongle, how do I setup)
-Crius CO-16 V1.2 OLED display (is this even useful)
VTX - Eachine TS832 FPV 5.8Ghz 32ch 600mw
Camera - 960h 700tvl CCD
Ubec - 12v to 5v down step
Lighting - various lights
Charger - skyrc e4 balance charger
battery - turnigy 3c 2200mah batts (Own Already)
paraboard - tarot paraboard "pro"
VRX - Bosscam 7" lcd monitor clone with built in 5.8 RX (Own Already)
Props - gemfan 5x3 5030 triblabes
I also need to figure out what else I need so I can go with as few interruptions as possible. so far I have:
heat shrink
soldering iron (and associated items)
screwdrivers, wrenches
computer
programming abilities
other things that have been mentioned but I am unsure of
PPM RX (any single wire capable protocol that works on the APM 3.1 mini really)
ESC firmware upgrading, (do i need a usb adapter)
Stand offs?
battery tray/strap?
Wifi?
DVR?
Bullet connectors?
Sonar?
I need to pick a TX!
Thanks!
Frame - Tarot 280mm TL280H (glass/carbon mix)
Motors - DYS be1806 2300kv
ESC - emax BLHeli 20a (can I use 12a version)
Flight Controller - APM 3.1 mini
-GPS
-Bluetooth
-MinimOSD MAVlink (do I need a usb dongle, how do I setup)
-Crius CO-16 V1.2 OLED display (is this even useful)
VTX - Eachine TS832 FPV 5.8Ghz 32ch 600mw
Camera - 960h 700tvl CCD
Ubec - 12v to 5v down step
Lighting - various lights
Charger - skyrc e4 balance charger
battery - turnigy 3c 2200mah batts (Own Already)
paraboard - tarot paraboard "pro"
VRX - Bosscam 7" lcd monitor clone with built in 5.8 RX (Own Already)
Props - gemfan 5x3 5030 triblabes
I also need to figure out what else I need so I can go with as few interruptions as possible. so far I have:
heat shrink
soldering iron (and associated items)
screwdrivers, wrenches
computer
programming abilities
other things that have been mentioned but I am unsure of
PPM RX (any single wire capable protocol that works on the APM 3.1 mini really)
ESC firmware upgrading, (do i need a usb adapter)
Stand offs?
battery tray/strap?
Wifi?
DVR?
Bullet connectors?
Sonar?
I need to pick a TX!
Thanks!