new to hobby aircraft and quads, here's my first build. Feedback?

What do I need to remove and replace? (post why)

  • motors

    Votes: 0 0.0%
  • esc's

    Votes: 0 0.0%
  • camera sensor

    Votes: 0 0.0%
  • VTX

    Votes: 0 0.0%
  • VRX

    Votes: 0 0.0%
  • frame

    Votes: 0 0.0%
  • blades

    Votes: 0 0.0%
  • Flight Controller

    Votes: 0 0.0%

  • Total voters
    0

jamerslong

New Member
Hey I am planning my first quad build. I would like to offer my shopping list for a little feedback anything that is wrong in your opinion or something that's missing. The entire purchase will be from banggood.com.

Frame - Tarot 280mm TL280H (glass/carbon mix)
Motors - DYS be1806 2300kv
ESC - emax BLHeli 20a (can I use 12a version)
Flight Controller - APM 3.1 mini
-GPS
-Bluetooth
-MinimOSD MAVlink (do I need a usb dongle, how do I setup)
-Crius CO-16 V1.2 OLED display (is this even useful)

VTX - Eachine TS832 FPV 5.8Ghz 32ch 600mw
Camera - 960h 700tvl CCD
Ubec - 12v to 5v down step
Lighting - various lights
Charger - skyrc e4 balance charger
battery - turnigy 3c 2200mah batts (Own Already)
paraboard - tarot paraboard "pro"
VRX - Bosscam 7" lcd monitor clone with built in 5.8 RX (Own Already)
Props - gemfan 5x3 5030 triblabes


I also need to figure out what else I need so I can go with as few interruptions as possible. so far I have:

heat shrink
soldering iron (and associated items)
screwdrivers, wrenches
computer
programming abilities

other things that have been mentioned but I am unsure of

PPM RX (any single wire capable protocol that works on the APM 3.1 mini really)
ESC firmware upgrading, (do i need a usb adapter)
Stand offs?
battery tray/strap?
Wifi?
DVR?
Bullet connectors?
Sonar?
I need to pick a TX!

Thanks!
 

Top