Mikrokopter New 5D octocopter project

[Ellipz]

Almost finished with my latest design:

setup:
Kontronic Kora motors
full carbon / polyamide frame
5D remotehead with 360 yaw / 180 nick, seperate tx/rx

design:








build:

Frame (20x18mm rohre)


"dry" mounted Remotehead




fitting the Canon 5D MK II

Still waiting for some stuf in backorder to get this beast ready for launch...

 

[Kilby]

Very nice work ellipz! What do you do your modeling in?

 

[ctbon]

ellipz, that is very, very cool!

 

[koolkiwikat]

Dude thats amazing stuff!, wish I had the skills and gear to have done what your doing!

 

[Ellipz]

thx guys, i'm trying to do my best.
@Kilby: i use BricsCAD v11 platinum (a belgian ACAD clone). I has everything you need and i prefer it above higher ACAD versions because it is so very lightweight, fast and incredibly stable. I must admit tho i do the renders in ACAD2011. I have been working with ACAD about 2001 versions back ;-)

Here's another picture of frame + gimbal.


BTW: other motors are possible too (axi's, robbe...)
If you requiry special electronic attachtment options like boards (HF, OP..., esc's, just ask).
All top quality materials, digital coreless servo's, timing belts, bearings...
A transparent dome will soon also be available.
The remote is delivered almost completely assembled and tested.

And as for pricing, pls PM or mail and be pleasantly surprised ;-)

 

[koolkiwikat]

PM me the cost for the frame + gimble, Im running arducopter etc etc so dont need any electronics, Cheers!

 

[Droider]

Thats one very impressive looking build.. good luck
dave