LeeT
Wannabe AP Dude
Hello,
I have recently built a FlameWheel F450 / Naza. This is my first quad, and really having a lot of fun flying (as opposed to crashing and fixing a cp heli). My problem is I cannot get the the Naza to go into failsafe mode when I turn off the transmitter.
TX - Spektrum DX7 setup in heli mode.
RX - AR6100E
I have setup the RX in the preset failsafe mode. Attitude or Manual mode is controlled by the gear switch. When I bound the RX to TX, I had the throttle set to 50% I know it works, as I can see the throttle move to 50% in the assistant when I turn off the TX.
I have created a program mix that allows me to manually put it into failsafe mode my switching on the Aux 2. When I did the preset failsafe, I had the Aux 2 in the on position as well as the throttle set at 50%. When I turned off the transmitter throttle moves to 50%, but it stays in either the A or M mode (which ever it was in at time of binding). If possible, I'd like to keep the Aux 2 channel free to turn on the LEDs when I get them.
What am I doing wrong?
Thanks,
Lee
I have recently built a FlameWheel F450 / Naza. This is my first quad, and really having a lot of fun flying (as opposed to crashing and fixing a cp heli). My problem is I cannot get the the Naza to go into failsafe mode when I turn off the transmitter.
TX - Spektrum DX7 setup in heli mode.
RX - AR6100E
I have setup the RX in the preset failsafe mode. Attitude or Manual mode is controlled by the gear switch. When I bound the RX to TX, I had the throttle set to 50% I know it works, as I can see the throttle move to 50% in the assistant when I turn off the TX.
I have created a program mix that allows me to manually put it into failsafe mode my switching on the Aux 2. When I did the preset failsafe, I had the Aux 2 in the on position as well as the throttle set at 50%. When I turned off the transmitter throttle moves to 50%, but it stays in either the A or M mode (which ever it was in at time of binding). If possible, I'd like to keep the Aux 2 channel free to turn on the LEDs when I get them.
What am I doing wrong?
Thanks,
Lee