I have a problem, please help.
DJI NazaMv2 will not start motors at combination stick command. All worked well before firmware upgrade.
Light sequence is normal at startup.
Intelligent mode is on
Everything is up to date.
Calibrations done. IMU ok. The stick calibration only reaches 985 for right aileron despite calibration. Possible issue?
Not in a no-fly zone.
Motors respond to motor direction check in assistant.
Replaced FC with brand new unit. All cabling and connections look good and yet problem persists.
Not sure what to try next.
Looking for connectors to do throttle calibration direct from RX but wary of altering too much as my knowledge is limited and all that is changed is a firmware update.
Any suggestions welcome
Rup
Tarrot 810
NazaMv2
Z15-GH3
Futaba 12/TM14/R6014
DJI NazaMv2 will not start motors at combination stick command. All worked well before firmware upgrade.
Light sequence is normal at startup.
Intelligent mode is on
Everything is up to date.
Calibrations done. IMU ok. The stick calibration only reaches 985 for right aileron despite calibration. Possible issue?
Not in a no-fly zone.
Motors respond to motor direction check in assistant.
Replaced FC with brand new unit. All cabling and connections look good and yet problem persists.
Not sure what to try next.
Looking for connectors to do throttle calibration direct from RX but wary of altering too much as my knowledge is limited and all that is changed is a firmware update.
Any suggestions welcome
Rup
Tarrot 810
NazaMv2
Z15-GH3
Futaba 12/TM14/R6014