Naza to reciever, signal wire only?

[solex_nl]

Hi all,

Sorry for the newb question, perhaps its been answered many times before.

I have the TBS Discovery, used the pins in the top board to transfer the signal from the Naza to the Frsky D8R-II.
I have 7 wires there, its a large hump of wires.
Is it possible to just use only the signal wire of 6 connections, and just one with signal, plus and ground??
That would make it cleaner.

Thank you very much.
Alex.

 

[kloner]

yes, that's the best way

if that receiver has ppm output, you can take it down to one 3 strand wire for the whole thing......

 

[solex_nl]

Thank you very much for the help!

 

[DesJardins]

Going S.bus/PPM is the best!

 

[solex_nl]

Not sure if my reciever can use ppm or s.bus
Never used ppm/sbus before.

http://www.frsky-rc.com/ShowProducts.asp?id=82

D8R-II(discontinued)
Category：2.4GHz Two Way Series

I was thinking about getting a other receiver as this one does not have a RSSI signal that is able to connect to the tbs/core.
Thanks again for the help.
Alex.