First off hello. I was in NZ not long ago and saw a guy flying a FPV up the side of a mountain and waterfall and I was hooked. Since then I have been looking and researching to build my own. For now I just want the ability to mount my Gopro and then FPV may come later. So far this is what I have come up with:
Q450 frame
For motors I have narrowed it to multistar 2213-980KV or turnigy D2830-11 1000KV. The D2830 is slightly better according to ecalc as far as efficiency and flight time so I'm leaning towards those. One thing I read is that the prop adapters that come with them aren't very good though, not a huge deal.
30A Afro ESC
HKPilot32
Neo-7 Gps
Somewhere around 5000mah batt 3s
Not sure on props as I haven't really looked yet but probably 10 inch
For transmitter and receiver if I buy the 9X set is that ok. I have no problem solder so I can flash it if I need to.
Any comments or suggestions are welcome. Thanks in advance!
Q450 frame
For motors I have narrowed it to multistar 2213-980KV or turnigy D2830-11 1000KV. The D2830 is slightly better according to ecalc as far as efficiency and flight time so I'm leaning towards those. One thing I read is that the prop adapters that come with them aren't very good though, not a huge deal.
30A Afro ESC
HKPilot32
Neo-7 Gps
Somewhere around 5000mah batt 3s
Not sure on props as I haven't really looked yet but probably 10 inch
For transmitter and receiver if I buy the 9X set is that ok. I have no problem solder so I can flash it if I need to.
Any comments or suggestions are welcome. Thanks in advance!