Macsgrafs
Active Member
Hi fellow addicts,
I have opened my servo, cut the leads off of the pot & soldered 2 x 2k5 preset trimmers in place. Im trying to use the servo to retract my undercart so that my camera op can have a full 360 degrees swing without the undercart getting in the way.
The problem I am finding is that I have to reduce servo travel to +/- 4%!!!!!!
Any clues anyone?
Ross
I have opened my servo, cut the leads off of the pot & soldered 2 x 2k5 preset trimmers in place. Im trying to use the servo to retract my undercart so that my camera op can have a full 360 degrees swing without the undercart getting in the way.
The problem I am finding is that I have to reduce servo travel to +/- 4%!!!!!!
Any clues anyone?
Ross