iseeit
Day or Night...
I am using the Maytech 85A ESC with my AXI 4120/20 motors.
When everything is connected (transmitter, receiver, ESC) I get 6 beeps from the motor (6 cell battery) followed by 2 beeps (brake off) as it should be.
Everything should be ready to start by using one of the combination stick commands (CSC) but the motors do not respond to any of the CSC.
I was told I needed to calibrate the ESC so I tried to program the ESC by doing the following:
No beeps!
Any ideas?
When everything is connected (transmitter, receiver, ESC) I get 6 beeps from the motor (6 cell battery) followed by 2 beeps (brake off) as it should be.
Everything should be ready to start by using one of the combination stick commands (CSC) but the motors do not respond to any of the CSC.
I was told I needed to calibrate the ESC so I tried to program the ESC by doing the following:
- Turned on transmitter and set throttle stick to maximum (Spektrum DX8).
- Turned on the receiver/DJI stuff as well (although the ESC instructions didn’t mention this step but what point is turning on the transmitter if the receiver is not on)
- Connected the ESC BEC connector (has no power) to the throttle port of the receiver (also not mentioned in the instruction but the ESC needs to see what the throttle is doing)
- Connect the battery to the ESC and wait 2 seconds for 2 beeps
No beeps!
Any ideas?
Last edited by a moderator: