male vs female

D

darrylC

Member
Hi all
Total newbie question. I'm gettin ready to start my first build (as soon as I finish renovating our bathroom) a 450 clone and all my parts have arrived. What I forgot to order though is the wires to connect the orange rx r910 dsm2 9 channel 2.4 GHz receiver to my APM 2.6 FC. According to hobbyking I need male servo connectors. Is that right? The rx and apm both have pins to connect to. Where I come from a pin is male and something that fits over it is female. Does the RC hobby world have this reversed?
And also what is the sbus port for? I think I figured out that I don't care about the satellite port for all
 



D

darrylC

Member
sbus is a single wire connection from futaba compatible rx's to a flight controller. some of those open source controllers do ppm through them too like ezuhf or dragonlink. but check first, not all, i never messed with apm[/QUOTE]

Thanx for the response.
 

FlyGirl

FlyGirl

Member
kloner said:
i use these guys, there good quality...
http://stores.servosandstuff.com/10-male-futaba-style-servo-connectors-30-gold-plated-pins/

using these
http://www.amazon.com/Engineer-PA-09-Micro-Connector-Crimpers/dp/B002AVVO7K

sbus is a single wire connection from futaba compatible rx's to a flight controller. some of those open source controllers do ppm through them too like ezuhf or dragonlink. but check first, not all, i never messed with apm
Click to expand...

I've been looking for a good pair of crimpers Kloner... Thanks!
 


You must log in or register to reply here.
Top