ThePlanttFPV
New Member
Hey everyone, I am relatively new to the drone building community and have been working on making a parts list for a 5 inch quad for quite a while and after a few other posts and many hours of research, I feel I have constructed a list of parts for a 5" 6s quadcopter build and I would like some advice on 1) If there is anything you think I should change out in the build, and 2) if the build is all compatible for what I am looking for (5 inch 6s quad). Thanks everyone, your advice is truly appreciated! I'll put the parts list and all of my gear down below.
Build:
- Rotor Riot CL1 Frame
- XRotor F4 G3 Flight Controller
- XRotor Micro 60A 4in1 ESC
- Ethix (Mr. Steele) Stout V3 Motors
- RaceDayQuads Mach 3 VTX
- Crossfire Nano RX
- RunCam Swift
- Lumenier AXII Antenna with MMCX Connector
- Thunder Power Adrenaline 1100mAh 6s Lipo Battery
- Ethix S3 Water Melon Props
Gear:
- Taranis QX7 (with TBS Crossfire Micro TX)
- FatShark HDO2 Analogue FPV Goggles
- Gopro Hero 5 Session
Build:
- Rotor Riot CL1 Frame
- XRotor F4 G3 Flight Controller
- XRotor Micro 60A 4in1 ESC
- Ethix (Mr. Steele) Stout V3 Motors
- RaceDayQuads Mach 3 VTX
- Crossfire Nano RX
- RunCam Swift
- Lumenier AXII Antenna with MMCX Connector
- Thunder Power Adrenaline 1100mAh 6s Lipo Battery
- Ethix S3 Water Melon Props
Gear:
- Taranis QX7 (with TBS Crossfire Micro TX)
- FatShark HDO2 Analogue FPV Goggles
- Gopro Hero 5 Session