Welcome To DroneVibes

DroneVibes is a COMMUNITY of drones enthusiasts. We are experts at drones for all professional and consumer applications. We welcome you to register and join the conversation.

Looking for some advice on a build!

Discussion in 'Drone Builds and Kits' started by ThePlanttFPV, Jun 27, 2020.

Tags:
  1. ThePlanttFPV

    ThePlanttFPV New Member

    1
    0
    1
    Jun 27, 2020
    Washington State
    Posted by ThePlanttFPV, Jun 27, 2020 #1
    Hey everyone, I am relatively new to the drone building community and have been working on making a parts list for a 5 inch quad for quite a while and after a few other posts and many hours of research, I feel I have constructed a list of parts for a 5" 6s quadcopter build and I would like some advice on 1) If there is anything you think I should change out in the build, and 2) if the build is all compatible for what I am looking for (5 inch 6s quad). Thanks everyone, your advice is truly appreciated! I'll put the parts list and all of my gear down below.

    Build:
    - Rotor Riot CL1 Frame
    - XRotor F4 G3 Flight Controller
    - XRotor Micro 60A 4in1 ESC
    - Ethix (Mr. Steele) Stout V3 Motors
    - RaceDayQuads Mach 3 VTX
    - Crossfire Nano RX
    - RunCam Swift
    - Lumenier AXII Antenna with MMCX Connector
    - Thunder Power Adrenaline 1100mAh 6s Lipo Battery
    - Ethix S3 Water Melon Props

    Gear:
    - Taranis QX7 (with TBS Crossfire Micro TX)
    - FatShark HDO2 Analogue FPV Goggles
    - Gopro Hero 5 Session
     
    Tags:
Loading...

Share This Page

Loading...