specksturm
Member
Hi!
My setup is:
Foldable H-Frame (wood) 50cm between rotors
T-Motors 2216-10 (900kv)
25A ESCs (simonK)
KK2. controlboard
Battery Zippy 3S 2800 30A
RX Frsky 8rD II plus
TX Frsky DJT
I had some problem in the beginning when i tried to start it up today. Motor nr1 was not reacting in the same way as the other motors. It came on pretty late when i cranked up the throttle.
But later on when I changed settings on the RX every motor got silent. I ofcourse changed it back and then suddenöy all the motors where fine.
So i went outside to fly. And because it was my first time flying anything rc it was tricky. But must say it went pretty OK.
But then I flew in to the foliage of a tree and the quad fell down a meter or so and in this accident the battery somehow got ripped out from the quad.
I went home to changed battery and when I plugged it in the ESCs and motors played their tune. But the KK2 board screen is lit up but blank and it won't arm either. Any ideas what this could be and is it something that I can try to fix my self?
My own theory is that because it had been raining before there was still some water on the leaves in the tree that got on to the control board and it shortened. Or could it be that it wont take any kind of hits?
Any suggestions I could try out?
My setup is:
Foldable H-Frame (wood) 50cm between rotors
T-Motors 2216-10 (900kv)
25A ESCs (simonK)
KK2. controlboard
Battery Zippy 3S 2800 30A
RX Frsky 8rD II plus
TX Frsky DJT
I had some problem in the beginning when i tried to start it up today. Motor nr1 was not reacting in the same way as the other motors. It came on pretty late when i cranked up the throttle.
But later on when I changed settings on the RX every motor got silent. I ofcourse changed it back and then suddenöy all the motors where fine.
So i went outside to fly. And because it was my first time flying anything rc it was tricky. But must say it went pretty OK.
But then I flew in to the foliage of a tree and the quad fell down a meter or so and in this accident the battery somehow got ripped out from the quad.
I went home to changed battery and when I plugged it in the ESCs and motors played their tune. But the KK2 board screen is lit up but blank and it won't arm either. Any ideas what this could be and is it something that I can try to fix my self?
My own theory is that because it had been raining before there was still some water on the leaves in the tree that got on to the control board and it shortened. Or could it be that it wont take any kind of hits?
Any suggestions I could try out?