High Current OSD

[Fat Corgi]

I have a eLogger/OSD from EagleTree (the 150A version), which I am looking to install on a new Octocopter. However, my current draw may exceed the 150A that the eLogger is rated for by some 10A (according to eCalc). Has anyone encountered this situation before, or found a way to work with it?

 

[kloner]

i install the current sensor on one of the two batteries and split the numbers to figure it all out. Gives a pass through if something failed,,,, been doing that with 100 amp current sensors for a while now.... 6s epic lifters