avrdude.exe: warning: cannot set sck period. please check for usbasp firmware update. avrdude.exe: AVR device initialized and ready to accept instructions Reading | ################################################## | 100% 0.01s avrdude.exe: Device signature = 0x1e9307 avrdude.exe: NOTE: FLASH memory has been specified, an erase cycle will be performed To disable this feature, specify the -D option. avrdude.exe: current erase-rewrite cycle count is -50462977 (if being tracked) avrdude.exe: erasing chip avrdude.exe: warning: cannot set sck period. please check for usbasp firmware update. avrdude.exe: reading input file "tgy.hex" avrdude.exe: input file tgy.hex auto detected as Intel Hex avrdude.exe: writing flash (2068 bytes): Writing | ################################################## | 100% 0.51s avrdude.exe: 2068 bytes of flash written avrdude.exe: verifying flash memory against tgy.hex: avrdude.exe: load data flash data from input file tgy.hex: avrdude.exe: input file tgy.hex auto detected as Intel Hex avrdude.exe: input file tgy.hex contains 2068 bytes avrdude.exe: reading on-chip flash data: Reading | ################################################## | 100% 0.61s avrdude.exe: verifying ... avrdude.exe: 2068 bytes of flash verified avrdude.exe: safemode: Fuses OK avrdude.exe done. Thank you. Don't know if it works. I made a little youtube clip also http://www.youtube.com/watch?v=i_FYmgZAAS4 Fredde |
It depends on which firmware the Turnigy has, earlier ones have 3.1 and you need 4.1 HiModel and HobbyWing now have 4.1 TC's reflashed with Simonk firmware at Abusemark are good providing that you are not running 14 pole flat low Kv motors These need 30 degrees of advance which normally only comes with 40Amp and over ESC's with 4 timing options.