CarbonCore
Member
Hello to everyone reading!
I'm Cameron at CarbonCore, based in East Yorkshire.
I've been flying RC for about 15 years now - started on 2ch slope gliders.
Flown helis and used 3D CAD for about 8 years.
I'm a regular flyer at the YMAS club, Bossal, near York.
[FONT=&]I'd like to share my Hexacopter Multicopter setup and first flight results.
After spending too much time with plastic props and a HoverFly SPORT Flight Controller,
I changed to a DJI Naza FC and Graupner Style Carbon props.
Setup:
Pulso U28-M motors (2814-22) 760 Kv (Same as Avroto and many others)
Carbon 11" x 5.5" props
HiPro 40A ESCs (400Hz)
2x 4S 5000mAh Zippy LiPo Batteries
Gains in this video:
Atti Gains 200-200 with 220 Yaw and 100 Vertical Gain. Basic gains on 90-90.
Yaw and vertical to be turned-up.
Flight done in Manual Mode.
This video is without any payload.
Flying Weight is 3150g and typical flight time is 15 minutes.
Has also been flown with 3Kg of payload.[/FONT]
I'm Cameron at CarbonCore, based in East Yorkshire.
I've been flying RC for about 15 years now - started on 2ch slope gliders.
Flown helis and used 3D CAD for about 8 years.
I'm a regular flyer at the YMAS club, Bossal, near York.
[FONT=&]I'd like to share my Hexacopter Multicopter setup and first flight results.
After spending too much time with plastic props and a HoverFly SPORT Flight Controller,
I changed to a DJI Naza FC and Graupner Style Carbon props.
Setup:
Pulso U28-M motors (2814-22) 760 Kv (Same as Avroto and many others)
Carbon 11" x 5.5" props
HiPro 40A ESCs (400Hz)
2x 4S 5000mAh Zippy LiPo Batteries
Gains in this video:
Atti Gains 200-200 with 220 Yaw and 100 Vertical Gain. Basic gains on 90-90.
Yaw and vertical to be turned-up.
Flight done in Manual Mode.
This video is without any payload.
Flying Weight is 3150g and typical flight time is 15 minutes.
Has also been flown with 3Kg of payload.[/FONT]
Last edited by a moderator: