Hello from Cameron at CarbonCore in Yorkshire UK

CarbonCore

Member
Hello to everyone reading!

I'm Cameron at CarbonCore, based in East Yorkshire.
I've been flying RC for about 15 years now - started on 2ch slope gliders.
Flown helis and used 3D CAD for about 8 years.

I'm a regular flyer at the YMAS club, Bossal, near York.

[FONT=&amp]I'd like to share my Hexacopter Multicopter setup and first flight results.

After spending too much time with plastic props and a HoverFly SPORT Flight Controller,
I changed to a DJI Naza FC and Graupner Style Carbon props.

Setup:
Pulso U28-M motors (2814-22) 760 Kv (Same as Avroto and many others)
Carbon 11" x 5.5" props
HiPro 40A ESCs (400Hz)
2x 4S 5000mAh Zippy LiPo Batteries

Gains in this video:
Atti Gains 200-200 with 220 Yaw and 100 Vertical Gain. Basic gains on 90-90.
Yaw and vertical to be turned-up.

Flight done in Manual Mode.


This video is without any payload.
Flying Weight is 3150g and typical flight time is 15 minutes.
Has also been flown with 3Kg of payload.[/FONT]
 
Last edited by a moderator:

CarbonCore

Member
CarbonCore now has a new office phone number +44 (0) 1759 368755

And I'd like to share some new photos of the Y6 Co-Axial Multicopter.
The Y6 has always been part of the CarbonCore range.
Co Axial multicopters have better stability in wind however slightly reduced flight time due to propeller configuration efficiency.

View attachment 7487 View attachment 7488 View attachment 7489 View attachment 7486 Call
Send SMS
Add to Skype
You'll need Skype CreditFree via Skype
 

Attachments

  • CarbonCore Y6 Co Axial 650 (4).jpg
    CarbonCore Y6 Co Axial 650 (4).jpg
    154.9 KB · Views: 620
  • CarbonCore Y6 Co Axial 650.jpg
    CarbonCore Y6 Co Axial 650.jpg
    159.6 KB · Views: 633
  • CarbonCore Y6 Co Axial 650 (1).jpg
    CarbonCore Y6 Co Axial 650 (1).jpg
    155.6 KB · Views: 659
  • CarbonCore Y6 Co Axial 650 (2).jpg
    CarbonCore Y6 Co Axial 650 (2).jpg
    155.6 KB · Views: 603

Top