Hi Folks,
Have the Naza set up in my new Hex all balanced with new Averticalview video gimbal.
I was able to get it in the air with no issues, seemed to fly great. It's all balanced and hovers nicely. A little drifting but not bad for the first couple flights.
But then the weirdness starts. And I really appreciate any feedback here as this seems like this might to be a tough one to figure out.
Like I said, it seems to lift off the ground nicely, fly for a few minutes, then fly a little farther out maybe 20 yards or so.
At a certian point in time the darn machine out of the blue starts to wander to the right. I start to compensate with a bit of cyclic to the left, moving the stick farther over and farther over until I'm at full cyclic to the left to just make it hover and then barely get it to the grougn safley. If I were to left off the right stick and center it the machine would shoot off to the right way out control.
I tried this with two different sets of packs today, fully charged.
The one thing I did do earlier today was I had to rebind as I set up the DX8 telemetry module.
I though this was the problem for some reason so I unhooked it. Unfortunately the problem of it shooting off to the right still occured.
Thanks very much for any help with this.
Have the Naza set up in my new Hex all balanced with new Averticalview video gimbal.
I was able to get it in the air with no issues, seemed to fly great. It's all balanced and hovers nicely. A little drifting but not bad for the first couple flights.
But then the weirdness starts. And I really appreciate any feedback here as this seems like this might to be a tough one to figure out.
Like I said, it seems to lift off the ground nicely, fly for a few minutes, then fly a little farther out maybe 20 yards or so.
At a certian point in time the darn machine out of the blue starts to wander to the right. I start to compensate with a bit of cyclic to the left, moving the stick farther over and farther over until I'm at full cyclic to the left to just make it hover and then barely get it to the grougn safley. If I were to left off the right stick and center it the machine would shoot off to the right way out control.
I tried this with two different sets of packs today, fully charged.
The one thing I did do earlier today was I had to rebind as I set up the DX8 telemetry module.
I though this was the problem for some reason so I unhooked it. Unfortunately the problem of it shooting off to the right still occured.
Thanks very much for any help with this.
Last edited by a moderator: