Hey guys. I excitedly went out today to do the initial flight test of my freshly built cinestar 8 with mkboards only to be cut short when I couldn't get more than 10-15ft away without signal dropping completely. I did some testing and even putting the transmitter behind my back at 5-6 feet away cut the connection severely.
I have the MX20 with a GR16 receiver. I also have a mx12 with GR12 for my gimbal (but these were not in use at the time) with this combo I have no issues with range at all in the same location.
I tested the MX20 and receiver on my gimbal and also had the same signal issues, so I am assuming it is a receiver and/or transmitter issue. Will the MX12 work in the mean time with the gr12 to fly the cinestar while i work these issues out? Any ideas?
Thanks so much!
I have the MX20 with a GR16 receiver. I also have a mx12 with GR12 for my gimbal (but these were not in use at the time) with this combo I have no issues with range at all in the same location.
I tested the MX20 and receiver on my gimbal and also had the same signal issues, so I am assuming it is a receiver and/or transmitter issue. Will the MX12 work in the mean time with the gr12 to fly the cinestar while i work these issues out? Any ideas?
Thanks so much!