Hey guys,
In the middle of my first fpv racing quadcopter build and have a few questions. Many thanks in advance to any help. I've spent literally dozens of hours on youtube and many nights filtering through forums and being told to read stickies to weed out the answers to my questions. I'm really tired to be honest hehe.
In this picture, I need some honest opinions whether you think I should resolder this in order to avoid potential crossing from the pos to neg. Or can I apply some hot glue and be ok?
[/URL][/IMG]
Here I soldered the motors to the ESC's... they weren't labeled so I followed a video where three was no real order, they just soldered them straight across. I'm assuming I can change the directions in CleanFlight.
Now with these 20a opto ESC's I can't power my Naze like I've seen in many videos. I cannot find one showing how to properly power a Naze REV6 using a BEC. I'm hesitant to try something and just end up frying my boards and shiz. Is the following diagram OK? (Paint skills Level: Max)
PDB to BEC
BEC powering Naze through number six.
Rx being powered by a servo cable through 1, 2 and 3 (3 for signal)
Questions:
Also, I'm not sure exactly where to connect the Rx to use telemetry for voltage. Would it be the Tx/GRND on the D4R to the GRND/VBATT pins on the Naze?
How can I power my FPV camera/reciever if they will need 5V instead of 12V. Is it done through multiple BEC's, dedicated PDB or can I simply splice the power leaving the BEC?
In the future I'd like to add LED's, would I blow them to smithereens if I connected them directly to the PBD.
Pencil's down!
Thanks again so much.
In the middle of my first fpv racing quadcopter build and have a few questions. Many thanks in advance to any help. I've spent literally dozens of hours on youtube and many nights filtering through forums and being told to read stickies to weed out the answers to my questions. I'm really tired to be honest hehe.
In this picture, I need some honest opinions whether you think I should resolder this in order to avoid potential crossing from the pos to neg. Or can I apply some hot glue and be ok?
Here I soldered the motors to the ESC's... they weren't labeled so I followed a video where three was no real order, they just soldered them straight across. I'm assuming I can change the directions in CleanFlight.
Now with these 20a opto ESC's I can't power my Naze like I've seen in many videos. I cannot find one showing how to properly power a Naze REV6 using a BEC. I'm hesitant to try something and just end up frying my boards and shiz. Is the following diagram OK? (Paint skills Level: Max)
PDB to BEC
BEC powering Naze through number six.
Rx being powered by a servo cable through 1, 2 and 3 (3 for signal)
Questions:
Also, I'm not sure exactly where to connect the Rx to use telemetry for voltage. Would it be the Tx/GRND on the D4R to the GRND/VBATT pins on the Naze?
How can I power my FPV camera/reciever if they will need 5V instead of 12V. Is it done through multiple BEC's, dedicated PDB or can I simply splice the power leaving the BEC?
In the future I'd like to add LED's, would I blow them to smithereens if I connected them directly to the PBD.
Pencil's down!
Thanks again so much.