Hood49
Member
Guys,
I am a bit puzzled here.
I have set up my quad. It goes like a house on fire! However, there is a bit of a wobble when flying. It does not hamper flying but it is a bit annoying. After doing some research I have found out that I did not calibrate my (OPTO)ESC's. So I suppose that is the problem.
No, I have watched some interesting video's on YouTube. They all advise to connect every ESC one by one to the receiver in the throttle port. Fire up my DX6i, leave the throtlle un FULL, connect the Lipo and bring the throttle down. It should beep.
Now I have something strange. When I take out the throttle cable coming from the Naza Lite controller the receiver (AR6210) has no power (the small light does not come on). So there is no way I can calibrate (of course I had removed all the ESC cable from the Naza). All the other wires are still connected to the receiver (ail, elev, rudd,...)
So how can I calibrate?
Tough one..
Any ideas?
Thanks in advance.
I am a bit puzzled here.
I have set up my quad. It goes like a house on fire! However, there is a bit of a wobble when flying. It does not hamper flying but it is a bit annoying. After doing some research I have found out that I did not calibrate my (OPTO)ESC's. So I suppose that is the problem.
No, I have watched some interesting video's on YouTube. They all advise to connect every ESC one by one to the receiver in the throttle port. Fire up my DX6i, leave the throtlle un FULL, connect the Lipo and bring the throttle down. It should beep.
Now I have something strange. When I take out the throttle cable coming from the Naza Lite controller the receiver (AR6210) has no power (the small light does not come on). So there is no way I can calibrate (of course I had removed all the ESC cable from the Naza). All the other wires are still connected to the receiver (ail, elev, rudd,...)
So how can I calibrate?
Tough one..
Any ideas?
Thanks in advance.