Totallycommitted
Member
Hey all,
I have a problem with a configuration I am looking to setup and wanting to know if anyone has any solutions or ideas for me ...
Build will be an mk octo, and I am wanting to use the Av200/360 camera gimbal with this. However it seems as though there are not enough power outputs from the wkm controller to power/control both 8 motors and the roll/tilt from the cam gimbal.
Is it true that I have to sacrifice the octo for the hexa in order to run the whole config. through the wkm, or is it possible to use separate stabilisers for the roll/tilt so that I can still use the octo config. ???
All help greatly appreciated
Matt
I have a problem with a configuration I am looking to setup and wanting to know if anyone has any solutions or ideas for me ...
Build will be an mk octo, and I am wanting to use the Av200/360 camera gimbal with this. However it seems as though there are not enough power outputs from the wkm controller to power/control both 8 motors and the roll/tilt from the cam gimbal.
Is it true that I have to sacrifice the octo for the hexa in order to run the whole config. through the wkm, or is it possible to use separate stabilisers for the roll/tilt so that I can still use the octo config. ???
All help greatly appreciated
Matt