aerialagents
Member
I had an issue with my original circuit board for Phantom 2. So i purchased a new one, reinstalled everything, soldered everything exactly as it was before. I ran the advanced calibration, rebinded the controller, calibrated again etc. On the Assistant Software it shows all my controls running fine.
My problem is now the X1 tilt lever under the controller for the gimbal, although the AS says its working fine is not responding.... Is there anything I can do to fix this?
My problem is now the X1 tilt lever under the controller for the gimbal, although the AS says its working fine is not responding.... Is there anything I can do to fix this?