NerV-Runna
Member
Hey guys
This one has me scratching my head.
Iv built and setup 30 or more WKM's and alot more naza's on various frames. All using a Futaba 8FGS for WKM and T8J for nazas.
Everyone Iv built, when doing the compass calibration, its worked flawlessly.
1.Enter calibration mode using control mode switch.
2. Blue led lit.
3. horizontal rotation.
4. Green led lit.
5. Vertical rotation
6. White led
The one im trying to calibrate now, just simply will not calibrate! All goes as it should until the vertical rotation.
Nothing I do will give me a successful calibration (white flashes)
All I get is red flashes.
I have tried:
Repositioning the GPS.
Rotating the GPS.
Doing the horizontal & vertical rotations in all directions and manners.
Moving various components.
Changing firmware.
trying different locations. (the field I always use which has always worked fine and two others)
All with the same result. Red flashes after the vertical rotation.
Any ideas?
Thanks
G
This one has me scratching my head.
Iv built and setup 30 or more WKM's and alot more naza's on various frames. All using a Futaba 8FGS for WKM and T8J for nazas.
Everyone Iv built, when doing the compass calibration, its worked flawlessly.
1.Enter calibration mode using control mode switch.
2. Blue led lit.
3. horizontal rotation.
4. Green led lit.
5. Vertical rotation
6. White led
The one im trying to calibrate now, just simply will not calibrate! All goes as it should until the vertical rotation.
Nothing I do will give me a successful calibration (white flashes)
All I get is red flashes.
I have tried:
Repositioning the GPS.
Rotating the GPS.
Doing the horizontal & vertical rotations in all directions and manners.
Moving various components.
Changing firmware.
trying different locations. (the field I always use which has always worked fine and two others)
All with the same result. Red flashes after the vertical rotation.
Any ideas?
Thanks
G