Build Log - Oktokopter (MK, AD8 HL)

[ZeHd]

After install the arms into the center-plate and glue aluminum ESC Cooler there is too many wires so I decide shortening the wires where they connect to the ESC's. Like Droid suggestion I´ll solder motor wires direct to BL's.
I must admit that was quiet challenge put all parts of the frame together.
Today I´ll remove the short wires with bullet connectors from the PDB and remove the engine connectors.

View attachment 1600View attachment 1601View attachment 1602

Regards,

Jose Luis

 

[ZeHd]

Installed JSt connector on the Extension-PCB - Done!
View attachment 1606
ESC´s wires removed and installed power cables - Done!
View attachment 1608
Solder engine wires - Done!
View attachment 1609
Extra dumper to make more room to the ESC´s coolers - Done!.
View attachment 1610

Regards,

Jose Luis