masterbeatty
Member
Hello
I am trying to configure my pixhawk to auto retract and auto deploy my servo landing gear. The auto function in mission planner 3.3 only deploys the gear when landing but does not auto retract. I have searched and searched to find a answer. This subject seems to not have much detail in how to wire and configure so i was wondering if anyone has done this?
I have the aux1 port rc_10 to my Y cable to the landing gear servos
I tried the config set to landing gear per the arducopter wiki and nothing
I tried setting it up as a parachute and nothing
On the mission planner tabs in the flight window i see there is a tab for servos but i have tried toggling all of them and nothing again.
Is there something i am missing?
I am also running a spectrum ar6200 six ch rx and a orangeRX t-six.
This is why i can't use the 6th ch as an aux since mission planner doesn't allow ch6 to be used as anything other than tuning.
I am trying to configure my pixhawk to auto retract and auto deploy my servo landing gear. The auto function in mission planner 3.3 only deploys the gear when landing but does not auto retract. I have searched and searched to find a answer. This subject seems to not have much detail in how to wire and configure so i was wondering if anyone has done this?
I have the aux1 port rc_10 to my Y cable to the landing gear servos
I tried the config set to landing gear per the arducopter wiki and nothing
I tried setting it up as a parachute and nothing
On the mission planner tabs in the flight window i see there is a tab for servos but i have tried toggling all of them and nothing again.
Is there something i am missing?
I am also running a spectrum ar6200 six ch rx and a orangeRX t-six.
This is why i can't use the 6th ch as an aux since mission planner doesn't allow ch6 to be used as anything other than tuning.