View attachment 10670During TX calibration, Futaba T6J, I am unable to centre the Aileron. With subtrim cranked down to zero I can get it in the green but still flies off to starboard
Aileron wont centre
- Thread starter ojuice22
- Start date
kloner
Aerial DP
every once in a while building these i hit this....... sometimes re binding the rx helps, other times i move to another pc and what you show looks all lined up...... make sure the trims and sub trims are center and recalibrate a couple more times. Last week i had it happen and i recalibrated till the program crashed, when it came back up it was perfect.
nee-hao
friggin things, but they sure fly good.
alot of times especialy in manual but masked in atti, a motor not up to par will make it drift off to one side. you can see motors like that cause they stop spinning before others, will have a bad vibe if felt spinning. if it drifts right, check the right side, if other, check left side motors
nee-hao
friggin things, but they sure fly good.
alot of times especialy in manual but masked in atti, a motor not up to par will make it drift off to one side. you can see motors like that cause they stop spinning before others, will have a bad vibe if felt spinning. if it drifts right, check the right side, if other, check left side motors