Jrocks
Member
Hello all,
This is more of a radio question but being set-up on an S800 so hoping I'm posting this in the right place. Tried searching for the topic and didn't get anything.
I'm a new S800 owner and have my 3-way mode switch dialed in but can't figure out how to set-up the failsafe switch. I'm assuming I have to assign failsafe to a different switch and mix them? So I have the ability to switch on Failsafe separately? If so, can't figure out how to do this.
Also, this might be a silly question but for your throttle gimbal do you start (motor idle before take-off) at mid stick or stick at the bottom? I'm a helicopter flyer and switched the model type to "Airplane" to avoid the Heli mixing problems but then it hit me that I wasn't sure if I should mechanically change my throttle gimbal to the "Airplane" verison.
Any help from fellow 14MZ/S800 users is greatly appreciated.
Thanks!
This is more of a radio question but being set-up on an S800 so hoping I'm posting this in the right place. Tried searching for the topic and didn't get anything.
I'm a new S800 owner and have my 3-way mode switch dialed in but can't figure out how to set-up the failsafe switch. I'm assuming I have to assign failsafe to a different switch and mix them? So I have the ability to switch on Failsafe separately? If so, can't figure out how to do this.
Also, this might be a silly question but for your throttle gimbal do you start (motor idle before take-off) at mid stick or stick at the bottom? I'm a helicopter flyer and switched the model type to "Airplane" to avoid the Heli mixing problems but then it hit me that I wasn't sure if I should mechanically change my throttle gimbal to the "Airplane" verison.
Any help from fellow 14MZ/S800 users is greatly appreciated.
Thanks!