Search results

Right I think I got that part. But say I set the rate on the fail safe switch while the flight mode switch is in the GPS position. Does that mean the failsafe switch will only work when the flight mode switch is on GPS position? If it is, is there a work around that will allow the failsafe to...

I think I get the basics. So in Mixing are the rate values equivalent to travel and the offset equivalent to center position or subtrim? In the case of mixing a channel to itself and that channel being connected to a 3 position switch, is the center position of the slave switch dependent on...

Here is the video. My question was about assigning failsafe on the Naza v2 to a switch rather than having it trigger only when signal is lost. I also wanted to maintain Manual as the third mode on the flight control switch.

Question about Mixing on Spektrum transmitters. I was researching a question I had regarding my flight controller and came upon a video where the guy was using mixing to solve the problem. Now I could probably just follow all the steps he did and get a solution to my problem but I have no idea...

What spektrum altitude telemetry module are you guys using? I just bought a TM1000 so I don't need one that will duplicate anything that module already does. Also do you have a suggestion of instructions for installing both on a naza equipped copter?

That's a good point. Maybe the 2nd time around it will be more relaxing since I'm not stressing out on what to do next or if I'm doing the current step correctly. It's probably like driving. When you first start out you're nervous and super cautious that you're doing everything correctly but...

I was switching back and forth because I wanted to get more comfortable flying in ATTI but I'm pretty sure it was in GPS because it was pretty steady and when I was on ATTI I would drift more.

Center position on both sticks.

Yah I think I will do a complete tear down and unsolder everything. Reassembly should be much faster now that I know what I'm doing (well somewhat anyways :D ) . My only fear is that that the problem wasn't mechanical and that there is a bug with the fc. I've read several posts and seen a...

Any recommendations / procedures to determine that all the connections are solid?

Oh and the battery got damaged as well. At least the outer sleeve. No punctures though. Is it still useable? If so, what should I use to re-wrap it? Giant heat shrink?

Both of the back booms and motor mounts were toast. Oh and the props of course. Fortunately the motor *seems* ok. I'll have to run it and see. I went ahead and ordered the replacement parts right now along with a couple of extra for future crashes and it was just under $100 with expedited...

So after a very long and first ever multirotor build, my Tarot 650sport quadcopter it decides to crash for no apparent reason. I was flying most of the day just fine, no problems whatsoever with the quad itself. The h3 3d gimbal on the other hand is another story. After 40+ minutes of flying...

I just picked up a used H3 3D and wanted to know how you guys go about adjusting it to get a smooth video. I installed it as is and it twitches randomly. Pitch value under Manual Control Speed was set to 100 and I assume that is the culprit. But what is the procedure / process to find the...

Do The zenmuse h3 or h4 have yaw control?

any recommendations for a gopro gimbal that allows you to control the yaw motion?

Is the MCU facing the right way?

My Naza V2 quad drifts several feet when I yaw. I added expo for a slower motion and that helps but it still happens. I see this a common problem online but I haven't seen a solution. Anyone have any suggestions?

Moving it to another CAN HUB port didn't work but unistalling and installing assistant strangely does.

I don't see that button. Only the top 3. I can see it on my phone when running the assisstant app so I'm assuming the btu should be working. Maybe I'll try another port in the CAN HUB