Search results

Now that esc calibration option has been removed from menu of the kk controller how do I do the calibration of esc's? Any help appreciated

Well I've spent all of Christmas trying to get my tbs motors to arm and work! The only thing I haven't tried because I read somewhere that's it already been done at the factory is calibrate the speedos (ie plug each one in, go to full throttle power up then down to read stock high points and low...

Yes sticks outwards and at bottom. Yes always unplug naza from PC when trying to arm. i am ready to throw the thing at the wall now. Should all the flight modes be in attitude or manual when arming? I only ask as I haven't set trims yet and some of the switches positions weren't on the right...

I tried csc (Bottom and out) and every other position just to be sure and still no success.

Really thought I had cracked it but no such bloody luck! I set up brand new model as I was using a model that a mate had left in the radio I bought off him. All channels are being read by the assistant and all arrows are green at centre (throttle goes black when it is not in centre, is this...

It's funny you mention trim but firstly yes to calibration after any changes, can't remember them being green (May have been black) but I'll check. i noticed earlier than the main screen trim showed it was a couple of clicks off Central which I corrected but still didn't work!

Yes the bar moves from left to right for full throttle. The end points are on 150% which is the max on dx8 (it's 125 on DX6i), should they only be 100?

So I sorted the wiring issue but now have another conundrum and would really appreciate some help. Disco is all set up with base settings etc but can't get throttle channel sorted to operate motors. if I have throttle channel in normal on assistant and normal on tranny I can't arm and operate...

Sussed it and can't believe what it was! The servo leads I bought were wired back to front so the signal and negative wire were reversed! I never spotted it as I assumed all was fine as long as I was plugging in the servo leads the correct way round into receiver and naza! unbelievable and...

using a r8000 spectrum receiver with dx8,

Basically I was worried that the chassis plate connections might be faulty so instead of plugging in receiver via the chassis I just plugged the leads direct from the naza to the receiver. yes just tried re-installing the software and driver with quad plugged in and still no luck. As I say I get...

Issues connecting new disco/naza v2 into pc So I finished building my disco and wired it all up following naza instructions. After binding the receiver the first thing I did was plug it in to naza assistant but it didn't read the quad at all. So after a bit of head scratching I decided to hard...

So I finished building my disco and wired it all up following naza instructions. After binding the receiver the first thing I did was plug it in to naza assistant but it didn't read the quad at all. So after a bit of head scratching I decided to hard wire receiver direct from naza unit and hey...