So I finished building my disco and wired it all up following naza instructions. After binding the receiver the first thing I did was plug it in to naza assistant but it didn't read the quad at all. So after a bit of head scratching I decided to hard wire receiver direct from naza unit and hey presto it worked.
This told me It could be a problem with the board so I checked the board by running a current through all 8 connectors and putting a mulitmeter on each one and they all read the correct voltage (I forgot to do the 3rd pin on each so I will do that tomorrow).
The weird thing is I went to plug it in to PC again by the direct route but it wouldn't connect to PC this time even though at the bottom of screen it says 'mc on' in green.
When I say doesn't connect it is not picking up the stick movements.
I bound the receiver so I know it's not that or at least don't think it is!
Any help appreciated
This told me It could be a problem with the board so I checked the board by running a current through all 8 connectors and putting a mulitmeter on each one and they all read the correct voltage (I forgot to do the 3rd pin on each so I will do that tomorrow).
The weird thing is I went to plug it in to PC again by the direct route but it wouldn't connect to PC this time even though at the bottom of screen it says 'mc on' in green.
When I say doesn't connect it is not picking up the stick movements.
I bound the receiver so I know it's not that or at least don't think it is!
Any help appreciated