Search results

Never been flown, still in box. 100% working. $500 Buyer pays shipping. Inbox for more details. Or mail me at gareth@sadrones.co.za G

As new, never been flown. $1000 ONCO Buyer pays shipping Gareth

DJI ZENMUSE GH3 GIMBAL FOR SALE Brand new! Never been flown! $1000 Reason for selling: I have too many gimbals. Buyer pays shipping :) Gareth

Gimbal never been in the air. Like new. $1100 Buyer pays shipping G

2x DJI ZENMUSE GH3 GIMBAL IN BOX. OPENED, ASSEMBLED & TESTED, NEVER FLOWN. $1800 each ONCO. Reason for selling, customer changed his mind and wanted 5Ds instead. BUYER ARRANGES SHIPPING. I LIVE IN SOUTH AFRICA :) It is normally cheaper for the customer to organise the shipping. Regards...

Hey everyone! Im having an issues with my hexa, its a Y config. Eg. When hovering, (in both ATTI and GPS mode) I give some rudder to yaw. The copter yaws say 45 degrees, but when i release the rudder, it returns to its original direction. To rotate it and keep it rotated, i find I have to...

Hey guys This one has me scratching my head. Iv built and setup 30 or more WKM's and alot more naza's on various frames. All using a Futaba 8FGS for WKM and T8J for nazas. Everyone Iv built, when doing the compass calibration, its worked flawlessly. 1.Enter calibration mode using control mode...

I want to make a trainer cable for connecting a Futaba 8J to a Futaba 8FG-S. I think iv looked at so many trainer/buddy box iterations that I can no longer make a sound descision. Pin outs on the Futaba square 6 pin din connector are: 1: NC 2: GND 3: SIGNAL OUT 4: +V 5: +V SWITCHED 6: SIGNAL...

So iv read the manual to death, but cant quite get a grasp on the POI feature. You plug everything in, wait for a GPS fix. Then flick your IOC into POI mode. Obviously the FC has chosen a POI in front of the copter, but how far away? If you take off, and start rolling right (rotating around...

I just finished building an F550 with Naza + GPS. She flies beautifully, but occasionally yaws by 5-40 degrees spontaneously. Once even spun 360. Transmitter I'm using is futaba 8j. With s-bus. Everything is calibrated and setup correctly. Any ideas? Thanks G

Hey everyone :) Lets say I have a quad that flies for 20min on 2x 6200mah 3s lipos. Its lifting capacity is 2kgs excluding batteries. How much extra time will I get if I add another 2, 4 or 6 batteries? I know this is a relative question, but im just trying to figure out at what point does...

Its not very clear in the manual, or perhaps im just blind. But will the WKM run 8 motors and 2 servos for gyro camera mount or only 6 motors when you use F1 & F2 for servos? Thanks! G:)

Im getting a MK octocopter XL frame. Im looking to use the Turnigy G25 motors. Will these motors be sufficient??? Also it says on the HK site that I should use 14x7 props. Should I? Or should I use the 12x4.5? Or 14x4.5 The specs for the G25 are: Spec. Battery: 3~4 Cell...

Hey everyone, I need some advice with regards to a custom build octo. Im building an octo frame that can carry a droidworz slr camera mount, hence quite a payload including the camera. I want to use the following motors: C2836 KV880 Aeolian The specs are...