Search results

i had 4 months and hundreds of flights under my belt when one time i spooled it up and a prop shot up like a kids toy......... no spring,,,,,, you want it all balanced as can be

any of you guys have a nice camera that does macro? can anybody post some pictures of there solder......... show the esc connections to the board best you can if possible

it's hard to tell without a way to measure internal resistance is there a chance the board is cracked? hold a light across it and just make sure there isn't something pysically showing that could do this...... very weird show/tell us your low voltage settings

there really really sharp. just cupping it in your palm when you tighten them will slice ya open.... a countersink looks like this it's like a drill bit but doesn't have that bite like a drill bit. a stone one works too, like the three on the left. Your trying to let the nut go down .5mm ish

ar8000 did too does a dx6 bind to any channel rx?

ya, that lookin into part is the ar7xxx where the regular multichannel failsafe starts?

this was from the other side.... sounds crazy that flight was 4 minutes and burned 2000mah,,, it carries 6000mah

got to use this thing yesterday. no wonder everybody has that thing..... thanks for the recomendation dude, you done good. powerful as hell and so small. love it

do the same 8" on 4s, 10" on 3s,,, just in apc

well i'll be........ look ma, no hands sure looks scarry flyin around like that,,,,, i'll upload another view. Gonna get a 5n for this kinda stuff and use this 5a for the water flying.

one other thing came to mind, that receiver doesn't have a multi channel failsafe, i'm not sure how that works, but you might look further into it

to protect them from shorts....... a loose gopro connector could light it on fire, loose piece of solder floating around, helps prevent Thanks this is Team Blacksheep

i swore i replied to this, but guess not. You need to get a common connector on all your stuff. battery and charger come with something, usually doesn't match. the dji kit doesn't have any, just two piece of wire. some use xt-60, others deans. Whatever you do, make em all the same and avoid any...

i've been reading all through there. they got a uav program at the local college...... flying wings........

if it came off after the crash, it should rip the solder pad off the pcb before the wire leave the pad. it is most likely why it crashed..... make the joints nice and wet, lotsa solder and don't move while it cools

stock 2212, then yea, good idea. you'll see they don't tighten left alone. on mine, i ran em a very short time, but i just countersunk my nut..... i know, wtf did he say? hahaha no seriously, just ran a countersink in there a half mm and they sinched down snug. without it slips a little all...

we all know how well that goes over here in the US........ hard cold time and the money still + penalty + interest +costs

you'll like em, just be careful. get any washers?

I had that with 2217 suppo, around 2kilo there not enough.......... I'm 2568 AUW, still waiting on this stupid nimh

no, it was some guy at rcg, his screen name was the name of the thing, from polland. Lemme look, i'll find. He posted at fpv lab once, everybody asked questions then they linked the rcg thread. i pm'd him like it said to get one but never heard back EDIT: i looked and looked, i don't see it...