Search results

you have to remove it, but you need it to program them first..... shut off LVC by changing it to nimh, set the hard or fast start, no gov, i know i'm ofrgetting something, oh, run the throttle calibration on each first... might still be something i'm forgetting

Leopard 2814 750kv, something new coming up. i'll be trying them with the ipeaka simonK esc's

hobbywing pentium 40 need programing first including throttle calibration then most folks that want to keep them somewhat in tact just unclip the red wire from the servo plug, fold it back and heat shrink it. Then you can get back into program them again,,,, to just cut it and turn a blind eye...

in case i forget, remind me to get the air splitter file to you. gotta fine tune it, testing it out tomorrow. might need to be smaller, but it's wicked. Chris said it'll work. If you see this thing floating by you do me a favor and grab it. Were flying the pacific tomorrow

same here, mines in san diego now,,,, wohoo

like how it insulates it from the voltair

perma grin,,,, sweet

Theres myself and another guy flying multirotors up around sorrento alot. there will be more soon cause there all digin the discovery. Sunday afternoon alot of us are getting together at "little beach" in carlsbad aka Daves Beach. You can los fly, fpv fly, watch the rest of us go at it...

makes since. i'll heat shrink only, think it'd be easier to dry bare than all covered in goop. is there voltage coming out of the camera osd lead? out the gimble lead? all that from this little switching supply on the board? it's alright like that? got the voltair on, rc rx on, it almost...

I'm 99% sure thats the customs broker location they have to pass through..... so there all going to pass through there to get into the US

http://www.multirotorforums.com/showthread.php?6797-the-revolution&p=70198#post70198

http://www.openpilot.org/#

in gps it's "hucking it" around the corner and in atti, you have the gain too high to let it let you do that. move it down, slowly, start at 80 and try sliding it down to 50. it's gonna get loose, but feel it.....

try changing the atti gain.... whats it at now?

say a guy wanted to live life on the edge and every gram was important....... think a thick heat shrink would work alright to protect it from elements, wind, minor damage? I mean, i'm thinking if it goes in it'll be a wad of CF and pcb so whats a tupperware gonna save? I'm a hero or zero 99% of...

Why isn't ppm input supported? is there any future plans?

it's all clear through there. file the edges in case any copper crosses the top and bottom when you do it...... i have one thats cutoff 1/4" in front of the bottom boards rubber band mount and the board cam part is just gone.

dragonplate is expensive, but diverse in there offerings and ship like that. if you need anything cut, send them the file and ask for a quote, you might be surprised. cutting is like free compared to there material pricing. but, the matt finish material is really nice. my favorite eye candy...

gotcha.... weird. did you calibrate the tx in "tx cali" after switching over to ppm did you ever do that calibration with the DL? with that plug on rx and tx flashing red/green?