Search results

it kinda showed it in the video clip he made, just didn't realize that was what was showing. The link is bad.....

to me and through my experience, i'd consider it an unsafe practice. It'd be similar to the science behind why you shouldn't drive drunk...... the whole delayed response thing

you don't have to cut it, in case you want to program the esc later with the card, you cn unclip it form the servo end and fold it bac, heat shrink it. I take and unplug the red and black wires from the end and strip those back to the esc then either unsolder or trim the wires so they can be...

http://www.castlecreations.com/promos/black5day.html

my balancer was all trimmed out for 8" graupners and the tips were gone on the part that goes into the hub so can't say for certain what i saw was true, but on my magnetic balancer they looked side to side perfect, but seemed like the hub was off a hair....... Seem to fly fine, but had a little...

imagine talking to a guy with those on.... hahaha sup dude,,,,,,,, So all your overlaying is the osd info onto the glasses? no view out the cam to frame with?

there sure nice. mines 2814 on 4s at 3.7kilo hex and there dead on. really quiet

yes, that's how i run mine. Some osd's need a ground with the yellow wire so start in that direction with wire, they bail the black one if you don't need it Glad to hear about the influence. rock on

it's hard to say........ usuallt that look is the wrong channel between the two. has the vtx been ran without a antenna? the voltage going to them is dead on?

to set the throttle range, you fire up each esc on the throttle ch of the receiver and follow directions. it is usually boot the esc at full throttle, no prop and drop the stick after 2 seconds and you get a tone. that shows the esc's what top, bottom and center throttle are. All radios are...

1. the ubec is too big, it's only problem. makes more noise than necessary. The whole thing will draw around 1 amp cam and vtx 2. no your not better off. it is the noisiest way to get power and will screw with your packs I ran that powersupply on a model that didn't live more than a couple...

the XY....

the ornithopter humingbird is awesome..... That guy has balls, or is just flat dumb to state all that on tv. This is the flick Trappy got his whole story twisted around...... they told him it was for one thing then was edited another

hahaha, you'll see it has 240 amps of esc's and am hoping to make some speed runs with one pack...

that's how barts is

these are the same thing, but the high end ones. The plastic "snap" is just really tight. guess it should be....... there 6mm bullets like castle sells. not that whimpy little stuff, hahaha if they got "lube" on em, there would be no way to get em apart.

hahaha, wtf my dogs aint locked up, it's the battery connectors are hard as hell to get apart

if mine didn't work so well i'd see if my old versions did it. just opened 1.6 and it looked pretty normal, didn't have that error If i remember right, you click ok when it says that and it continues to work.....

Just finished a build and used these progressive rc prc6 connectors, but man what a pain to get em appart. Any tricks? http://www.progressiverc.com/prc6-connectors-2-pairs.html

Can you rotate the image on a nex5 like on gopro where you swap what up is? I can do it post, but everything is mirrored,,,,, am i missing something?