Search results

i love flying giants...... the 3d planks was my last habit before these

stable video with hero3 All my planks have flight controllers, same reason. that and self leveling is a bonus. I run eagle tree osd pros w/ guardian in one.... cc3d in another, ruby in 2 others....

so as i'm healing been getting back to my feet a little at a time. Was able to finish out my other ZXL that's a GP hero based rig running all the same fpv stuff except it has a CC3D flight controller and Eagle Tree osd...... just a smaller camera mount. it's super aero and should give some long...

doesn't sound like the cali stuck... it should have made a beep sequence after lowering the stick. i'd try again

depends how good you are with a drill. that is definately a downside...... the gear are kinda flimsy, maybee look into something higher end for the bottom anyways? http://www.altitudehobbies.com/brushless-motors/leopard-brushless-motors there gonna be there..... you might email garret what...

good question. The 22mm stuff will be here next week,,,, think there might be some 28mm motors but there 900 kv so that sucks....... it's not a 12" prop motor like the prototypes i got. There alot like tigers......

that's how they are. when your eyes in there it seems like it's really big

the twitch is a general sign of over propped,,,, motors are having a hard time reving and slowing...... leaving a stop light in 2nd gear kinda thing

yes it will pull more amps, but that's the idea as you get heavier is to up the props so your manual hover is near mid stick. when the props don't do it, you add more volts, then that's not enough, needs bigger motors. in general, the recomended prop/cell counts are for a bone stock nothing but...

i have something similar am setting up now. the 2814 750 kv motors work killer. Mines 3.8kilo, carries 8000mah except i use 40 amp esc's and am settling on 12x8 props. 12x5 works, but not enough power. A friend of mine has a similar rig and his is settling on 12x6. To the best of my knowledge is...

couple things to point out,,, if the gps's suck, move those ant apart. if the video reception sucks, make the top of the antenna higher

in setting this up, no matter what i do with acceleration the thing is jumpy. what does that, gimble? servo? balance? this recording is acceleration 0 honestly, never owning this kinda thing i have no idea if this is what i bought or if it can be better.

realizing we both have the pad you say doesn't work, working...... that zeal didn't work on mine. i've had really good luck hanging gopros from it, but setting it on it never fixed my jello. what does is the ear plugs, full size on there sides, 2 bottom, 2 top and the thinnest lightest rubber...

dragon plate is a super high quality material. there cutting services are super reasonable too. they lay the weave 45 degrees to each layer. you can use thinner material for the same strength

same with ear plugs, as loosely on there without squishing them. Take and stretch the thinnest rubber band you can find into length

as loose as possible without it physically shaking

you want the immersion 5.8 600mw vtx.

no but my kid sure does, all after her

guess i missed the sticky :livid:

Never setup a gimble so bear with my ignorance. The manual is really vague unless i missed something. I've got the greenboard hfp running the 4.6.0.2 firmware. the gimble is a tilt only AV100 bone stock with the savox servo. Got it really close but i don't understand whats doing what. What...