Search results

Thanks. Now i need to decide what to buy!

Can anyone give me advice on the best option for a good transmitter and receiver for live video. I want to plug it into my nikon D7000. Thanks. Dan

My throttle is in reverse on my TX. If i change from normal to reverse in the TX in the menu the tx doesn't work. I though this would solve the issue. In the Wookong software the TX has been calibrated correctly.. Bu this doesn't sole the backward T control. I have also tried to reverse the...

I have just tried that. I have now got the roll to work, but still no luck with Pitch. The pitch wont adjust when i move the control on my TX.

All sorted now.. Now trying to get the gimble working. It is plugged into the R and T port. I ma using S BUs. There is power in the servos, but they wont move when i move the controls on the transmitter. I have programmed them in as AuX 1 and 2. Any thoughts.

I am in the process of setting up my Cinestar 8 with a wookong controller. with the Futaba 8FG super. The wookong ans tx is working, but the motor aren't turning. They were turning before!. I think maybe the esc's are damanged. I was in the garden testing the motors 2 days ago. All appeared...

Hi Sar This is the first time i have set it up. I have the motor turning, and they seem to be set up fine. But not the GPS. As Ross says, it is set into the s-bus output. Also can get the gimble to work.

I am having problems setting up the wookong. The software wont allow me to change the control mode switch. It is set at A. and the slider wont move. It say the MC output is off. Dan

I have a new cinestar8 and setting up the wookong controller. Any recommendation of the best setting would be appreciated to get me started. Dan

I wan to fly over water and film some wildlife. I am little nervous, but want people experiences. I will be taking off from a boat, and landing on the deck. Has anyone put floats on their rig? I plan only to fly in zero wind, and flat seas. Dan

thanks for that Lars. Dan

Thanks. for that simple reply..Is there any other setting i need to address, or shall i wait till i make my maiden flight! Dan

Just got a 8fg super, and need to config for my ocotcopter . I have the Wookong M controller. Can anyone assist me on setting it up. It say i need aerobatic mode. Where is this in the menu? Many thanks Dan

Some of you may have seen this. Anyway like to share it, http://www.youtube.com/watch?feature=player_embedded&v=YQIMGV5vtd4#! Dan

I will make the board. Using some 10awg wire.

I assume this will work with all of the kit i have. Has anyone tested it out with the same config?

I have a Wookong M, and running a CInistar8 with a spectrum 8. I have run out of port on main controller, as they are all full of the ESc's I need to run the SLR gimbal and need an additional two ports to run the gimbal. I was informed i need a S bus converter. Anyone out there use one, and can...

HI Alex Did you try to contact me the other day. Dan

Just building my new Cinestar 8 with wookong controller. (first copter built) Just wanted to see how other have layed out the parts on their model. Any pics would be appreciated. Thanks Dan

Hi Stevey I spoke you you last week a bout the cicestar8. I bought one from Geoff, and putting it together.Just wondered if you have some pics you can send me to see how you have put the Wookong on the rotor, and how the power distribution was mounted. There isn't much extras that come with it...