Search results

Interesting. We had our slow fly APC on for testing as our Xoars would not stop slipping.

Thanks Pete. Will give it a go.

Our CCW motors are running hot on our Hex. Our assumption is this is an issues with Yaw setup. Any tips on tuning this out?

Brilliant.

I want to be able to test/compare the motor and esc against each other to see if we have a weak link. The challenge is to do this with the craft fully constructed. My idea is: 1) Isolate each motor by removing the feed from the DJI for the other motors. 2) Measure amps drawn by the motor at...

Exactly! Hence our surprise and confusion. This is how it came from PhotoHigher.

100% with you IrisAerial and we have re-read everything many times. The challenge is our servo does not have the brass end of the internal pot to adjust. When you remove the gears there is not pot there! Hence the cure using the external pot.

Hi Cedric - sorry you are very right. Our confusion is that there is no pot inside the servo to adjust. We have cured this by using one of the spare pots left over from the RSGS build. Thank you for your help.

It also spins just over 360 when we power up, then it settles down and stops!???

Thanks Cedric, We now have this working, but I have used all of the trim and sub-trim available to stop it moving! Is this normal? I have also had to increase the stick travel to 150%. (I also set up the DR to 20 and Expo to 100 - nice tip).

360 Pan Setup Thanks everyone for the input on this (especially Cedric). Can anyone explain how you have connected the PAN directly into the receiver. Ours only spins 1 way and we can only just get it to stop. (DX8 & AR8000).

GentWIRE Focus just arrived.

What kind of trigger does it need? I was hoping to rig the shutter up to a spare channel on the dx8.

Shawn - What remote shutter trigger setup do you use?

Thank you. Will give it a try.

It is 13.8v 28A, so 386.4 watt. Set to 13.5v and 28A in the PL8.

I have been playing around with the PowerLab 8 over the last few days and cant get it to go above 10A. I am running 4S 5000mAh packs capable of 5C and have created a custom fuel table for them. My power supply is 13.8v 28A. I am charging the packs in parallel (2 at a time)......can anyone put...

Hoping someone can help....just put the 360 option on our AV200 and connected the servo straight to the AR8000. When we power up, the servo just wants to spin at 0% input. It only stops spinning at about -130% input and just about creeps in the opposite direction. Can anyone relieve my frustration?

Really good point.

The camera can be controlled through IP and means anyone with a browser can see the live feed.....