Search results

EDIT: FIGURED IT OUT. TWO ESCs PLUGGED INTO WRONG CONNECTOR. YELLOW AND ORANGE LOOK PRETTY SIMILAR ON JUNK LAPTOP. :strawberry: I'm trying to get a HoverFly Sport board working on IrisAerial's FNF frame and have run into a problem I can't diagnose. While in the setup utility looking at the...

From what I'm reading, the M5 is built to hold up to 5 pounds, the M10 up to 10 pounds, and a M20 might be available down the road. Found the info here: http://blog.vincentlaforet.com/ Based on pictures, the multirotor version could be changed over to the handheld version by swapping some...

Hopefully soon! It is really impressive. I'm betting the shipping model will be even better...

Glad you guys dig it. Wouldn't have gotten it off the ground if it weren't for the awesome members of this forum.

The video explains it all...

Will said the latency was manageable when in the lowest setting. There might have been more latency in earlier firmware.

Here's a picture from the shoot:

This system had about 300+ yards of range with an HD signal and minimal delay. The range is longer if you can deal with more delay. Price is $20k. We would rent it for a shoot. We found it when we went hunting for a lightweight HD system for live broadcast. Gaylen was very helpful. He...

Hope you guys enjoy this one: We were doing a test of a wireless HD system from Nebtek and decided to film something fun for the test. The motorcycle rider is Heather Williams and she can be found here: www.Heather-Williams.com More on the Nebtek system...

Here is Fabien's (e-copter)

Well played.

I'd say you got Ken pretty good with that one.

I'll sell you a used Blade Mqx that would get the job done. Cost is $30,000 if you're interested. It even comes with large batteries for 2 hour flight times.

What size props are you running there?

That was my original plan, but I ran into this problem ( see the picture ). The screw heads weren't accessible. My daughter was determined to get her foot in the picture.

I'm with ya on that. I'll give it a try tomorrow. At some point though I think I'll figure out a way to turn it into a traditional coax. But I'm also thinking that the props will hang down too low and I'll likely go back to a flat octo. We'll see...

But are your motors offset? I think having the CW set closer in than the CCW set is causing a bit of weirdness. It's not crazy, it just yaws a bit when it corrects for a small breeze, which it didn't really do before.

What are you flying on your Cinestar currently? WKM? Just curious.

So I got the itch to try a coaxial today, but my motors are too fat to do the traditional stack with the motor-mount plates I have at the moment, so I tried offsetting them instead. Here is a picture of before: Here is a picture of what I mean by offsetting the motors (inspired by another...

Hoverfly Pro just plain rocks! Over 1500 flights on our Cinestar and I can rely on it every time.