Search results

went back to my faulty dx8 radio that i have to send in for repair and the flipping issue seems to be resolved. its weird that i can get such different results out of the radio. foam must of not helped, i tried doing a video a bit ago and this time the foam didnt matter. anyway i guess its good...

so anyone have any issues with sunlight with there hoverfly board i have the foam over it , was flying great for two flights this am then all the sudden the foam came loose and it flipped again. i tightend the foam back on it and it flies perfect again for three more packs. this is crazy..

i did it individually

well i just tried putting electrical tape and a small piece of memory foam over the hole and it actually worked. now this is nerve racking if this falls off in the sunlight i loose everything. is there a solution to this. ????

alright so last night i ran 6 battery packs through my bird and it was running almost flawless. i was speechless how amazing this FC was. i went inside sat it on the kitchen table went out this am to fly and now at about 1/4 throttle three of the motors go full speed and flip it right over. i...

alright hoverfly is fixed. i must be colorblind because the ESC wires were all in the wrong spot and then I reflashed the firmware and its amazingly stable now, however i do have a yaw issue which i though was in my dx8 radio but i switched radios and it still does it in the other radio too. soo...

doesnt change i placed it three feet off and gave her some beans and right over it went

neither go negative ill try getting it off the ground a bit right now. thanks

what its doing heres where im at

That is a big help! Also a setup video for your radio, when i go into travel /gains in my dx8 it only goes to zero and everything is saying to set it at -25 and 25, if i just get the radio setup im sure ill be flying right away. As of right now im still grounded with everything responding just...

yeah and checked that twice. in the setup utility when i connect it shows that everything is working correctly, i just tried again and it does the same thing wants to full power flip, also i have zero controls just throttle?

i have the HVP black board and i finally got it to arm. now i am having problems when im just under quarter throttle looking good like it will lift off it goes FULL power right upside down! im going to calibrate the board again and see if that changes . im using a dx8 ar8000 tx rx??

Naa, no worries yuri i have been on a four day video shoot with the ad agency Noise. Put like ten minutes into it. I did check two esc's and they were both correct, so next is post up a video of it when i get a second. Ill get it.. It might be those esc's... Im not worried at all

There showing all correct full throw.

so i recalibrated al the esc's and still have to re solder the power dist board, however last time i tried this the arming of the hoverfly is very weird not a left and right movement its a up down movement and then it arms . The motors will only power up together to one quarter speed. something...

i wanted the rx in the shot for the video so one can see what im exactly doing during the arming, i tried like fifteen times beofre filming

Thanks yuri, i normally do unplug first, I am stoked to get this up in the air. Frame seems really solid!!! I want to or three more now for backups etc

So originally i wasnt able to arm the hoverfly pro . I figured out now if upon plugging in the battery i move the stick to the top and then bottom it will boot up and allow motor movement. However the motors wont spool up to full speed, so im assuming i incorrectly setup the throttle range on...

Hw about this, http://www.pcworld.com/article/229364/sony_cybershot_dschx9v_review_long_zoom_innovative_extras_and_superb_video.html

thanks!