Search results

I had a similar problem, turned out that I had mounted the NAZA with velcro and it was shifting and getting too much vibration. Is your naza mounted firmly in the center of the Quad facing forward? Also take a look at the gps location in the software, the positive and negative values throw...

I'm flying a DJI f450 naza+gps. I have been running 10x5 DJI props and a 5000mah 3s lipo. I don't have a camera or gimbal installed yet but if flys quite well with this setup. I get somewhere around 10 min flight time before first warning. Motors and battery are cool after flights no matter how...

Well, I think I was inside 20M when I activated failsafe, but I'm pretty sure It went a good bit further than 20m from me before I started flipping switches (my guess is that it was 20m or more from where it was when I hit the failsafe switch when I toggled back to atti). I'll measure next time...

I think I have done it all correctly, the failsafe does turn blue. I have been testing RTH through the 3 position switch, changing from ATTI to Failsafe. The copter does stop hover for only 2 sec then gain altitude and proceed off in the wrong direction. I doesn't even seem to wait till it has...

Thanks, Know any reason in RTH mode the quad would fly the wrong way? I have the Gps pointing the correct direction (forward). Last test it went basically the opposite direction of me (I was at the launch point where I powered it up and waited for it to lock the satellites)

I just wanted to save someone else the headache I just went through. I have a DJI F450 Flamewheel w/ naza and GPS. I mounted my Naza with Velcro (the sticky kind). For the past 2 weeks I keep fighting my Quad because it always wanted to wander. On takeoff, it would try to veer one way or the...