Search results

I'm using a powerlab 8 with an efuel 1200W 60amp psu works great and loving all the info when connected to the computer, I would've got an icharger duo 4010 but there was no where in the uk with them at the time. For the price it's been a good investment. I have 8x 6s batteries and a Honda...

yes they are very good

i take my legs off every time, i only have to undo the power supply plug and the receiver plug, my braincube controller is on the leg. i have my vtx and antenna on the legs too and a fi-li-fi :)

i put mine on the legs front and back works well

yes Quinton you can, I have the braincube lights on mine and have the landing gear light to come on when the legs lower, i can also turn the landing gear light on and off

Google nimrod and blackhawk antennas they are the best I've used

free..... bargain!

the 3 position mode selection switch does work you have the 3 modes but have 360 degree rotation in fpv mode the orientation and non orientation works. the aux2 doesn't. i also have reported this. it affects all of them, i sent my first one back but my replacement is the same. how do you...

Hi Aaron welcome to the multirotor forum I'm down the road from you in Weston

I tried to show you fast and slow, I have it set so the more i turn the pot the faster it goes. I didn't set the camera up as I was in a rush sorry for the quality. Mine had the hard start and stop before adding the curves. Yes the GH3 Zen is noisier than the Nex Zen, I sent mine back because...

only 7 hours left for this bargain... http://www.ebay.co.uk/itm/321246235892?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649 it has the V2 hdmi

please excuse the video quality this is just to show my pan and tilt motion these are the function curves i use for pan and tilt

i rarely use roll so I'm not worried about that. tilt is not a real problem either as i can use the level on the camera but it would be nice to work as it should. yes i can tilt and roll in reset mode too. also in fpv mode the pan should stop at the degree you move your control not continue...

yes i will do a video tomorrow for you i can't do it right now. i am surprised to hear you have auto level on tilt and roll as i do not have it and Kopterworx do not. do you use wookong m? fpv mode should only give you 40 degrees left and right but i also have 360degrees.

Boris do you have aux2 control forward/downward facing? do you have auto level of tilt and roll axis when returning to reset mode? do you have full 360 degree rotation in fpv mode?

yes i have a smooth motion on all axis from standstill to moving. i have flat curves rising to speed the pan/tilt/roll rate as i turn my potentiometer in and out. I do not see a jump when starting the movement. do you have aux2 control forward/downward facing? do you have auto level of tilt...

have you tried adding some function curves on your tx? i have nice smooth motion on all axis by creating some custom curves. more to the point on the firmware we need auto levelling of the tilt and roll axis when going to reset mode and aux2 to work.

Thanks for letting me know that