Search results

has anyone else got this movement? it is bugging me it is causing my jib to lean to one side

it works fine with iftron tx and rx 1080i output on GH3 with monitor setting on PAL1

my take is the 6 flashes are recording home point when you start the motors. mine only does it once and all is good. i would forget everything about Naza that's totally different to Wookong M. no 20 flashes here.

its 6. 20 in the wkm guide is just an example to say purple flashing same as poi.

Thank you Lanzar I was thinking that was the case, you have saved me a lot of time trying to fathom this problem out. thank you

received my replacement zen gh3, i sent my 1st one back because of this problem but the replacement is the same.... going into reset mode the zen will pan back to centre, but won't roll or pitch back to centre, everything looks ok in both the assistants and the firmware is all current. aux2...

Wow that was an interesting read. Pretty cool rain man!

Good feeling to see it flying. 15mph is a slight breeze for a SJ6 mine flies well in 25mph :)

Also remove the lens cap

Mine made that exact same noise I sent it back and should get a replacement tomorrow. I will let you know if the new one makes the same noise. Is your aux2 control working? ie have you got forward/down control on a 2way switch? And does the tilt auto level when resetting? Mine did not.

to remove the top of the motor undo the circlip on the bottom and remove the washer and the motor will pull apart.

Does your aux2 work?

Tx and rx

It works fine with iftron tx and tx. Wish I could say the same for the rest of it. Has anyone actually got a fully functioning gh3 zen? I just sent mine back today hope it's replacement works out the box.

Thanks Carapau for the reply. Yes I thought so as is my NEX Zen. Strange I have full 360 degrees but my aux2 forward/down doesn't work and when I reset, the tilt doesn't level automatically. I have levelling on all 3 modes and orientation and non orientation modes work as they should and all...

does your gimbal rotate 360 degrees in fpv mode? or is it limited to 45 degrees either way?

yes my gps is on top of the cage and no problems with it there. That is why they have redesigned the cage and the centre plates with the upgrade it can be removed easier. If you look at my pics you can see that I put my bolts upside down to make it easier to access.

I have a load of the Droidworx battery mounts, I ordered 2 sets as I didn't realise they came with the kits and Droidworx didn't tell me that when ordering, same with the red boots.... anyway yes they are pants so I never used them. I used the gps mounting brackets and made some carbon fibre...

i also have 360 pan in fpv mode which was limited to about 45 degrees either side on the NEX Zen, is this normal for the GH3 Zen?

yes the GH3 definately records in progressive at 72Mbps in MOV format whilst outputting 1080i to the hdmi. I have mine up and running but have a problem with the forward/down orientation, I have it set up correctly and the assistant agrees to my stick movements but I cannot get the camera to...