Search results

I use them "out of the box" (just switched to NiMh and "low cutoff voltage"). best regards Ferdinand

On that copter I am flying right now 300 300 150 180 80 80, but it also flies with 200 200 150 180 80 80 as well as 400 400 150 180 80 80. I am using the Hobbywing 70A HV out of the box, they have no braking feature, also the brake is disabled. From my point of view this copter flies just...

Here my version of an X8, foldable and on the lightweight side: AUW is 9,5kg with 1,9kg battery and 2kg payload (zenmuse), flighttime is 30min. best regards Ferdinand

I have no comparison. As far as I know you can enable the legend in the view. best regards Ferdinand

You need the VPC module in addition to the flir tau. Then you can power the flir from an onboard source 5-6V and you get AV-out. (I am using a flir tau 640): best regards Ferdinand

It is staight forward to balance the gimbal. Also the setup in the software was not too difficult, but I am using an Alexmos-board. Edit: To zoom I use a servo that presses the buttons. best regards Ferdinand

If it is not for Video, there is no need for a 3rd axis. The flighttime of this copter is about 30min, range 2km, FPV-Equip is iftrontech TX/RX. RC is an Hitec Aurora9 best regards Ferdinand

Whatever gimbal you might find I would put them both on the same gimbal, since then you are able to zoom in (with the Sony) what you detected with the flir. Here my setup with Sony CX250 and Flir Tau 640: Here a video: Here the gimbal I am using: http://www.rctimer.com/product_912.html...

GensAce has a 16000mAh cell, it will be presentet during the spring exibitions. I already have 4S and 6S packs, 4S16000mAh has 1300gr, 6S16000mAh has 1900gr. best regards Ferdinand

129min 15sec flighttime Here my latest result: 129min 15sec best regards Ferdinand

It is a bit less than 4Gbyte a minute, so 9min -> 36Gbyte in Raw ProRes is about half of it

chacun à son goût but there are also other good prices: http://www.redcoon.at/B338482-SanDisk-SDHC-Extreme-Pro-32GB_SDHC My last flight was 28Gig in prores ... best regards Ferdinand

I think you will not be happy with 32GByte you will have to change after every flight.

Here my first test (really not more) with the Blackmagic on Zenmuse: it is a modded Z15N, the BlackMagic Pocket with the Olympus 14mm pancake, prores and added some "auto contrast" so see something but the fog. best regards Ferdinand

109min 46sec Here a flight of today, 109min 46sec 12mm frame 700mm m2m Tunergy Multistar 390kV 16P 18x5,5 foxtech props 12A Tunergy ESCs 4S4P GEB8043125 LiPo AUW 2100gr (700copter, 1400battery) ... and flown with LiPo best regards Ferdinand

May I ask you what HDMI-Konverter you are all using? Is there one witha micro HDIM kable on it? best regards Ferdinand

Hello John, The reason for the motors pointing down is, that the needed box (for transport) can be smaller, since the GPS-mast will be removed (FPV-Antenna can be turned), and then everything (motor,props, landing-legs, gimbal...) is below. The flighttimes are mostly due to the batteries used...

Here my two new foldable birds, "Snapper" with GoPro on Gimbal and FPV-cam, the "Manta" with GoPro on Gimbal only Flighttimes are 30 and 35min best regards Ferdinand

@anaka, ... and also got suitable lensen ... ... and also got a suitable SD-card? my status -> waiting for the SD-card best regards Ferdinand

One way 2,5kg payload, 20-25km one way, same copter, 0 payload 40-50km Possible config (but without foldability): best regards Ferdinand