Recent content by WayneMann

Hi Dorian, I am trying to figure out the PM system here on this forum so I also posted this a conversation. Anyway you can check us out at www.HeliCamHDmedia.com Have a great evening. Wayne Mann

If you want to test a gimbal board to see how well it handles horizon issues there are two things that you can do that will tell you everything that you need to know. First off you need the camera pointing at something with a flat horizon, not hovering behind a big bushy tree in a hilly...

I will be very curious to see if sun flares in the lens will be smoothed out. Typically if you have vibrating footage going into Warp Stabilizer the sun flares will still be shaking once the footage has been processed. I can't imagine that this will be any different. Wayne Mann...

Hi SamurAchzar, Thanks for the info. A lot of the gimbals would support it, the problem is the end user would have to retrofit the feed back sensors to the gimbal, which would open up a whole can of worms. But the professionals among us will do whatever is necessary, including spending quite...

Hi SamurAchzar, Will we ever see position feedback sensors for each axis like DJI and FreeFly uses on their gimbals? They can get away with much smaller motors than we can with AM based controllers as the motors have much more power around center with feedback sensors. Wayne Mann...

Thanks for the reply SamurAchzar. I look forward to trying one soon. Wayne Mann www.HeliCamHDmedia.com

Subscribed, You mentioned being able to tune the amount of accelerometer vs gyro being used. The AM boards have this ability as well, as you probably know but, on the AM boards if you give the gyros as much authority as possible the accelerometers still have too much leverage. If the camera...

The field of view with the camera I was using is the same as looking through the viewfinder as it was a wide angle camera. It covered the entire viewing area of the viewfinder. With live view you loose auto focus on the 5D which is very important as I have to get fairly close to some objects...

Hi guys, Well after doing a bunch of research and asking some questions I came to the conclusion that my X Aircraft woes with my Octo were largely due to ESC settings, so I went from a PWM of 8 to 12, which is the highest setting in the Hobbywing 60a Platinum ESC. I also went from 0 timing to...

Hi Ronan, No the board camera is attached to my video downlink. It lets you take pictures using the mechanical shutter as opposed to having to use live view and the electronic shutter. It is strictly for framing shots. Wayne Mann

Hi Guys, We do not do a lot of aerial photography, but we do have to shoot some occasionally. I am having trouble finding a replacement board camera that mounts to the view finder on the Canon 5D Mark ii. The connector on my board camera which is quite old finally took a dump and I can't...

Thanks Kloner. Wayne

Another quick question. The Ultra PWM setting in the Super X controller, can that be used with other controllers like the Hobbywing 60a Platinum ESCs or is that a specific setting for X Aircraft's ESCs. Thanks Wayne Mann

Hi Kloner, I enjoyed your Wind Tunnel video. This is the only wind tunnel I have access to and unfortunately I get to fly in these conditions all too often: https://vimeo.com/104156202 This was shot with my Wookong Octo with a mount that I built especially for the Gh4 which uses the 32 bit...

Thanks guys, Kloner, I checked out your reels on your site. You guys do some nice work. Wayne Mann