Recent content by Vortex

Thanks Bartman I found a good description on another forum which goes into a lot of fine detail in Engrish too :)

I've been buzzing around for over a year now with almost factory FC/GPS settings and thought it was how it was......Well, that was until I started flying an Inspire 1 around and it simply eats the MK FC for stability and position holding. I'm sure with the right settings that it can be fixed but...

Already we are finding there are licensed operators undercutting to win jobs for way below what the work should be paying. I guess they are under pressure to get some cash flow but it isn't doing anything positive for the industry and for the long term. Responsible operators who have a business...

Dazzab, there is a lot of what you describe going on everywhere at the moment. I spent 3 years getting our systems up and running to a standard I was happy with and by the time we had our UOC there were another 4 licensed operators in the same area. Now what's happening is some of the other...

I'd like to let everyone know HoverCam has been appointed a DJI dealer in Cairns QLD We have the Inspire 1 and Phantom 2 Vision+ in stock and ready to ship. We have over 20 years experience with RC Helis and MRs and are CASA approved ......... We can help with setup and flying training...

If you're planning to stop in Cairns, let me know, there's free coffee here also :) Regards, Lance

Interesting......Do you know where it says you can apply for an exemption in the regs and who has the 5m exemption??

Great clip Kloner......We have a 30 meter rule here and can't get any closer than that to persons or vehicles so we can't get anywhere near as close as you can. Keep up the good work :) Lance

We have been using a CAMRemote on our GH4 for a while and it works fine. All it'll do is focus and shoot or record but that's all I need it to do. As for using in on the Zenmuse someone else will have to chime in with that info. Regards, Lance

Welcome back......The new layout looks great. Thanks

I've connected up 5.0v external power to the converter board now and it seems to be a lot more reliable than when it was powered from the camera. I have not used it enough to say if has fixed the problem where the board would not convert every time when the camera was set to 50p but it seems to...

Kloner, I am running these converters and don't have them externally powered, the converter is supplied from the GH4 HDMI. It does drag the camera battery down a little quicker than without it but it is a whole lot more simple.

Thanks.....It's very nice!!!

Did you make the case or have it made for you??

I can understand advising users not to mess with things they do not properly understand nor are properly equipped to properly service but 99% of the bearings used in these motors are not sealed.......They are Shielded and there is a big difference. Sealed bearings have a contact lip seal which...